toolhead

printer.cfg

@@ -6,6 +6,11 @@
 
 [include mainsail.cfg]
 
+[mcu EBBCan]
+  canbus_uuid: 82edf63bd1a9
+
+[include toolhead.cfg]
+
 [stepper_x]
   step_pin: PC6
   dir_pin: !PA14
@@ -39,29 +44,10 @@ position_endstop: 207.890
   position_max: 232
   position_min: -10
   homing_speed: 40
-#second_homing_speed: 3
-#homing_retract_dist: 3
 
-# [extruder]
-# step_pin: PB3
-# dir_pin: PB4
-# enable_pin: !PD5
-# microsteps: 16
-# rotation_distance: 22.9
-# nozzle_diameter: 0.400
-# filament_diameter: 1.750
-# heater_pin: PC8
-# sensor_type: Generic 3950
-# sensor_pin: PA0
-# control: pid
-# pid_Kp: 20.837
-# pid_Ki: 1.037
-# pid_Kd: 104.708
-# min_temp: 0
-# max_temp: 275
 
-#[filament_switch_sensor extruder_filament_sensor]
+[filament_switch_sensor extruder_filament_sensor]
-#switch_pin: ^!PC15
+  switch_pin: ^!PC15
 
 # [heater_bed]
 #   heater_pin: PD8

toolhead.cfg

@@ -0,0 +1,43 @@
+# This file contains common pin mappings for the BIGTREETECH EBBCan
+# Canbus board. To use this config, the firmware should be compiled for the
+# STM32G0B1 with "8 MHz crystal" and "USB (on PA11/PA12)" or "CAN bus (on PB0/PB1)".
+# The "EBB Can" micro-controller will be used to control the components on the nozzle.
+
+# See docs/Config_Reference.md for a description of parameters.
+
+# [mcu EBBCan]
+# canbus_uuid: 82edf63bd1a9
+
+[adxl345]
+  cs_pin: EBBCan: PB12
+  spi_software_sclk_pin: EBBCan: PB10
+  spi_software_mosi_pin: EBBCan: PB11
+  spi_software_miso_pin: EBBCan: PB2
+  axes_map: x,y,z
+
+[fan]
+ pin: EBBCan: PA0
+
+[heater_fan hotend_fan]
+ pin: EBBCan: PA1
+ heater: extruder
+ heater_temp: 50.0
+
+[bltouch]
+  sensor_pin: ^EBBCan:PB8
+  control_pin: EBBCan:PB9
+  z_offset: 1.230
+
+# [tmc2209 extruder]
+# uart_pin: EBBCan: PA15
+# run_current: 0.650
+# stealthchop_threshold: 999999
+
+#[neopixel hotend_rgb]
+#pin: EBBCan:PD3
+
+#[filament_switch_sensor switch_sensor]
+#switch_pin: EBBCan:PB4
+
+#[filament_motion_sensor motion_sensor]
+#switch_pin: ^EBBCan:PB3