refactored added new LCD

config.h

@@ -0,0 +1,54 @@
+#include "Arduino.h"
+
+/* ----------------- General Config -------------------------------- */
+/* WiFi config */
+#define WIFI_SSID                   "poes"   // Your WiFi SSID
+#define WIFI_PASSWORD               "Rijnstraat214"     // Your WiFi password
+
+/* MQTT */
+#define mqtt_broker            "192.168.2.5" // IP address of your MQTT broker
+#define     REPORT_MQTT_SEPARATE  true               // Report each value to its own topic
+#define     REPORT_MQTT_JSON      true               // Report all values in a JSON message
+#define status_topic           "events"        // MQTT topic to report startup
+#define device_name            "AQS"
+
+/* Particulate Matter Sensor */
+#define    g_pms_warmup_period     30             // Seconds to warm up PMS before reading
+#define    g_pms_report_period    120             // Seconds between reports
+
+/* Use WiFi. If this is off, MQTT won't run */
+#define    ENABLE_WIFI       true
+
+/* Serial */
+#define     SERIAL_BAUD_RATE       115200              // Speed for USB serial console
+
+/* Environmental sensor */
+#define SEA_LEVEL_PRESSURE_HPA (1013.25)
+
+/* ----------------- Hardware-specific Config ---------------------- */
+/* Mode button connection (momentary between this pin and GND) */
+#define MODE_BUTTON_PIN    0
+
+/* RGB LEDs */
+#define WS2812B_PIN       13
+#define NUM_RGB_LEDS       0
+
+/* LCD */
+#define TFT_DC_PIN         2
+#define TFT_RST_PIN        4
+#define TFT_CS_PIN        26
+#define TFT_SCLK_PIN      18
+#define TFT_MISO_PIN      19
+#define TFT_MOSI_PIN      23
+
+/* I2C */
+#define I2C_SDA_PIN       21
+#define I2C_SCL_PIN       22
+//#define BME680_I2C_ADDR 0x76
+
+/* Particulate Matter Sensor */
+#define PMS_BAUD_RATE   9600
+#define PMS_SET_PIN       25
+#define PMS_RESET_PIN     26
+#define PMS_RX_PIN        27 //  Tx to the PMS SHOULD BE 16
+#define PMS_TX_PIN        14 //  Rx from the PMS SHOULD BE 17