# This file contains common pin mappings for Ultimaker UltiMainboard v2
# boards. To use this config, the firmware should be compiled for the
# AVR atmega2560.

# See docs/Config_Reference.md for a description of parameters.

[include macros.cfg]

[mcu]
serial: /dev/serial/by-id/usb-Arduino__www.arduino.cc__0042_8543034383735181D1B1-if00

[include UM2_v2.1.cfg]
[include bigtreetech-ebb-canbus-v1.2.cfg]

[printer]
kinematics: cartesian
max_velocity: 500
max_accel: 3000
max_z_velocity: 25
max_z_accel: 30


# [safe_z_home]
# home_xy_position: 100, 100 # Change coordinates to the center of your print bed
# speed: 50
# z_hop: 10                 # Move up 10mm
# z_hop_speed: 5

[bed_screws]
screw1: 120, 185
screw1_name: "rear mid screw"
screw2: 20 ,20
screw2_name: "front left screw"
screw3: 220, 20
screw3_name: "front right screw"
horizontal_move_z: 5

[bed_mesh]
speed: 120
horizontal_move_z: 5
mesh_min: 15, 50
mesh_max: 190, 200
probe_count: 5, 3

[filament_motion_sensor runout]
#   The minimum length of filament pulled through the sensor to trigger
#   a state change on the switch_pin
#   Default is 7 mm.
detection_length: 14.0
extruder: extruder
pause_on_runout: FALSE
runout_gcode:
  {action_respond_info("RUNOUT: Filament runout")}
  PAUSE
insert_gcode: {action_respond_info("RUNOUT: Filament inserted")}
#   The minimum amount of time in seconds to delay between events.
#   Events triggered during this time period will be silently
#   ignored. The default is 3 seconds.
#event_delay: 3.0
#   The amount of time to delay, in seconds, between the pause command
#   dispatch and execution of the runout_gcode. It may be useful to
#   increase this delay if OctoPrint exhibits strange pause behavior.
#   Default is 0.5 seconds.
#pause_delay: 0.5
##    XYE mcu E0DET
switch_pin: ^!PB7


[include mainsail.cfg]

#*# <---------------------- SAVE_CONFIG ---------------------->
#*# DO NOT EDIT THIS BLOCK OR BELOW. The contents are auto-generated.
#*#
#*# [stepper_z]
#*# position_endstop = 207.280
#*#
#*# [extruder]
#*#
#*# [bed_mesh default]
#*# version = 1
#*# points =
#*# 	  0.725000, 0.715000, 0.660000, 0.610000, 0.570000
#*# 	  0.660000, 0.650000, 0.600000, 0.575000, 0.485000
#*# 	  0.695000, 0.650000, 0.605000, 0.585000, 0.495000
#*# x_count = 5
#*# y_count = 3
#*# mesh_x_pps = 2
#*# mesh_y_pps = 2
#*# algo = lagrange
#*# tension = 0.2
#*# min_x = 15.0
#*# max_x = 190.0
#*# min_y = 50.0
#*# max_y = 200.0