# This file contains common pin mappings for the BIGTREETECH EBBCan
# Canbus board. To use this config, the firmware should be compiled for the
# STM32G0B1 with "8 MHz crystal" and "USB (on PA11/PA12)" or "CAN bus (on PB0/PB1)".
# The "EBB Can" micro-controller will be used to control the components on the nozzle.

# See docs/Config_Reference.md for a description of parameters.

# [mcu EBBCan]
# canbus_uuid: 82edf63bd1a9

[adxl345]
cs_pin: EBBCan: PB12
spi_software_sclk_pin: EBBCan: PB10
spi_software_mosi_pin: EBBCan: PB11
spi_software_miso_pin: EBBCan: PB2
axes_map: x,y,z

[fan]
 pin: EBBCan: PA0

[heater_fan hotend_fan]
 pin: EBBCan: PA1
 heater: extruder
 heater_temp: 50.0

[bltouch]
sensor_pin: ^EBBCan:PB8
control_pin: EBBCan:PB9
z_offset: 1.230

# [tmc2209 extruder]
# uart_pin: EBBCan: PA15
# run_current: 0.650
# stealthchop_threshold: 999999

#[neopixel hotend_rgb]
#pin: EBBCan:PD3

#[filament_switch_sensor switch_sensor]
#switch_pin: EBBCan:PB4

#[filament_motion_sensor motion_sensor]
#switch_pin: ^EBBCan:PB3