# This file contains common pin mappings for the BIGTREETECH EBBCan
# Canbus board. To use this config, the firmware should be compiled for the
# STM32G0B1 with "8 MHz crystal" and "USB (on PA11/PA12)" or "CAN bus (on PB0/PB1)".
# The "EBB Can" micro-controller will be used to control the components on the nozzle.

# See docs/Config_Reference.md for a description of parameters.

[mcu EBBCan]
#serial: /dev/serial/by-id/usb-Klipper_stm32g0b1xx_430057001150425539393020-if00
canbus_uuid: 82edf63bd1a9


[adxl345]
cs_pin: EBBCan: PB12
spi_software_sclk_pin: EBBCan: PB10
spi_software_mosi_pin: EBBCan: PB11
spi_software_miso_pin: EBBCan: PB2
axes_map: x,y,z

# [extruder]
# step_pin: EBBCan: PD0
# dir_pin: !EBBCan: PD1
# enable_pin: !EBBCan: PD2
# microsteps: 16
# rotation_distance: 33.500
# nozzle_diameter: 0.400
# filament_diameter: 1.750
# heater_pin: EBBCan: PB13
# sensor_type: EPCOS 100K B57560G104F
# sensor_pin: EBBCan: PA3
# control: pid
# pid_Kp: 21.527
# pid_Ki: 1.063
# pid_Kd: 108.982
# min_temp: 0
# max_temp: 250

sensor_type:MAX31865
sensor_pin: EBBCan: PA4
spi_bus: spi1
rtd_nominal_r: 100
rtd_reference_r: 430
rtd_num_of_wires: 2

# [tmc2209 extruder]
# uart_pin: EBBCan: PA15
# run_current: 0.650
# stealthchop_threshold: 999999

# [fan]
# pin: EBBCan: PA0

# [heater_fan hotend_fan]
# pin: EBBCan: PA1
# heater: extruder
# heater_temp: 50.0

#[neopixel hotend_rgb]
#pin: EBBCan:PD3

[bltouch]
sensor_pin: ^EBBCan:PB8
control_pin: EBBCan:PB9

#[filament_switch_sensor switch_sensor]
#switch_pin: EBBCan:PB4

#[filament_motion_sensor motion_sensor]
#switch_pin: ^EBBCan:PB3