initial commit

bigtreetech-ebb-canbus-v1.2.cfg

@@ -0,0 +1,69 @@
+# This file contains common pin mappings for the BIGTREETECH EBBCan
+# Canbus board. To use this config, the firmware should be compiled for the
+# STM32G0B1 with "8 MHz crystal" and "USB (on PA11/PA12)" or "CAN bus (on PB0/PB1)".
+# The "EBB Can" micro-controller will be used to control the components on the nozzle.
+
+# See docs/Config_Reference.md for a description of parameters.
+
+[mcu EBBCan]
+#serial: /dev/serial/by-id/usb-Klipper_stm32g0b1xx_430057001150425539393020-if00
+canbus_uuid: 82edf63bd1a9
+
+
+[adxl345]
+cs_pin: EBBCan: PB12
+spi_software_sclk_pin: EBBCan: PB10
+spi_software_mosi_pin: EBBCan: PB11
+spi_software_miso_pin: EBBCan: PB2
+axes_map: x,y,z
+
+# [extruder]
+# step_pin: EBBCan: PD0
+# dir_pin: !EBBCan: PD1
+# enable_pin: !EBBCan: PD2
+# microsteps: 16
+# rotation_distance: 33.500
+# nozzle_diameter: 0.400
+# filament_diameter: 1.750
+# heater_pin: EBBCan: PB13
+# sensor_type: EPCOS 100K B57560G104F
+# sensor_pin: EBBCan: PA3
+# control: pid
+# pid_Kp: 21.527
+# pid_Ki: 1.063
+# pid_Kd: 108.982
+# min_temp: 0
+# max_temp: 250
+
+sensor_type:MAX31865
+sensor_pin: EBBCan: PA4
+spi_bus: spi1
+rtd_nominal_r: 100
+rtd_reference_r: 430
+rtd_num_of_wires: 2
+
+# [tmc2209 extruder]
+# uart_pin: EBBCan: PA15
+# run_current: 0.650
+# stealthchop_threshold: 999999
+
+# [fan]
+# pin: EBBCan: PA0
+
+# [heater_fan hotend_fan]
+# pin: EBBCan: PA1
+# heater: extruder
+# heater_temp: 50.0
+
+#[neopixel hotend_rgb]
+#pin: EBBCan:PD3
+
+[bltouch]
+sensor_pin: ^EBBCan:PB8
+control_pin: EBBCan:PB9
+
+#[filament_switch_sensor switch_sensor]
+#switch_pin: EBBCan:PB4
+
+#[filament_motion_sensor motion_sensor]
+#switch_pin: ^EBBCan:PB3